Selection of Smart Conveyor / Assembly Lines
-
Tear strength
During use Each belt layer accepts a different amount of belt drive. When the belt passes through the pompom The lower surface rubber will cause pressure. The top surface rubber will be stretched. And each floor of your line received There is no difference between the material layers of the belt. There will be a problem. The damaging force is applied to each point of the belt in a circular motion. The pin can cause problems with separating the belt if the holding force of each layer is not strong enough. Conveyor product testing must therefore be tested.
-
Tilt-resistance properties of the belt About adhesion between each belt layer Abrasion Resistance
The belt will be rubbed all the time during use. Especially on the top rubber surface This is the part that comes in contact with the material to be conveyed to each type of material. Will cause different wear and tear Therefore must be checked every time in Production of conveyor belts
-
Resistance to environmental conditions (Environmental Resistance)
Conveyor belt applications have different characteristics. Outdoor use The surface of the belt to be used must be resistant to UV light (UV), silicon and ozone, which can catalyst the belt to deteriorate more quickly.
To contact with chemicals such as oil, press or alkali, etc. The surface of the belt should have properties that can withstand those chemicals.
-
Heat Resistance
The belt that passes through the pompom will have periodic deformation. This will cause the heat build up (Heat Build Up), especially the belt that is used to pull and walk around high will generate a lot of heat. Which may cause the tires to wear out quickly Than it should have been Another property that should be taken into account is the resistance to tension. And resistance to ultramodern The belt surface rubber must have sufficient tensile strength due to Must accept the tension used to drive the belt. And must be resistant to The exception is due to the deformation of the cycle mentioned above.
Source: http://engineerknowledge.blogspot.com